Flexx Handlebar Bends - Moto

Flexx Handlebar Notations and Definitions

• Cross Reference bar chart Please see the bottom of the page for a complete cross reference list of popular bar bends from other manufactures as well as OEM offerings. Please email or call us if you don’t see the bend cross reference you are looking for or you need help choosing the correct bend.
• Damper Crossbars Arched crossbars to accommodate over the bar steering dampers. Damper Crossbars can be added to any Flexx Handlebar. Sub/Fender Mount dampers do not require use of damper crossbars.
• Enduro Bends Our Enduro bends have a 1" narrower mid section shown as measurement (B) with full length handles of our Moto bend, providing plenty of room to trim to your desired width.
• Handle Length All Moto and Enduro bends offer 9” of handle room over an inch more than a traditional 7/8" or taper style bar. Adventure bends offer 10" of handle room.
• Accessory Applications Flexx Handlebar can be used with enduro computers, trip computers, GPS, steering dampers, roll charts, etc., etc. We offer a dash in our store section that will easily accommodate most GPS.
• Super Tenere/Adventure Bends The Super Tenere/Adventure bends are built on our narrow center section with longer handles, offering a full 10inches of handle room, easily accommodating all of your stock controls. We recommend Tenere customers use a threaded bar weight anchor to mount their stock bar weight/end caps. We offer threaded bar anchors in our store.  Any sweep can be built as a Tenere/Adventure bend.
• Low Bar Low Bar-The Low bends are incredibly low at 63mm of height. Low bends require 19mm of clearance between the bottom of the bar and the top of the fork caps. Low bends are designed to used with a under bar damper, bringing the bar height down to 10mm lower than stock height in most applications.
• All Flexx Handlebars require a 1 1/8" bar clamps.
• All bars are shipped with silver bar pads – many other colors are available.